Chapter 16: Sheet-metal Forming Processes and Equipment¶
第十六章：钣金成形工艺与设备
16.1 Introduction (引言)¶
16.2 Shearing (剪切)¶
- Punch and die (凸模与凹模)
- Clearance (间隙)
- Fine blanking (精冲)
16.3 Sheet-Metal Characteristics and Formability (钣金特性与成形性)¶
- Elongation (延伸率)
- Anisotropy (R-value) (各向异性/R值)
- Forming-limit diagrams (FLD) (成形极限图)
16.4 Bending Sheets, Plates, and Tubes (板材与管材弯曲)¶
- Springback (回弹)
- Minimum bend radius (最小弯曲半径)
16.5 Miscellaneous Bending and Related Operations (其他弯曲操作)¶
- Hemming (包边)
- Roll forming (辊压成形)
16.6 Deep Drawing (拉深)¶
- Limiting drawing ratio (LDR) (极限拉深比)
- Earing (制耳)
16.7 Rubber Forming and Hydroforming (橡胶成形与液压成形)¶
- Guerin process (盖林工艺)
- Tube hydroforming (管材液压成形)
16.8 Spinning (旋压)¶
- Shear spinning (强力旋压)
16.9 Superplastic Forming (超塑性成形)¶
16.10 Specialized Forming Processes (特种成形工艺)¶
- Explosive forming (爆炸成形)
- Magnetic-pulse forming (电磁成形)